Underwater Lights

Using a screwdriver, loosen the lock screws and remove the lens assembly from the fixture body.

Insert the lamp with the correct wattage and type as marked on the fixture label. CAUTION: Do not exceed the maximum wattage marked on the luminaire label. NOTE: DO NOT touch the lamp with bare hands. Use a soft cloth to handle the lamp.

Place the lens assembly back onto the fixture body and secure it with lock screws. Tighten until snug with a screwdriver.

Using the slots on the fixture base, mark the two mounting points. Using the marks, drill holes and insert the anchors. Place the fixture body onto the anchors. Pass the washers over the mounting screws and thread the mounting screws into the anchors to secure the fixture body. Hand tightens until snug with a screwdriver.